Replacing a broken set of blinds in my house and apparently no one sells the old standard kind where you pull the cord to raise them, I guess because kids and/or pets could tangle in the cord? Bit of an education in miniblinds today.

  • mumblerfish@lemmy.world
    link
    fedilink
    English
    arrow-up
    20
    ·
    edit-2
    2 months ago

    That is the only kind I know of. How does the other kind work?

    Edit: should have been more specific; the string ones are the ones I know of.

    • linearchaos@lemmy.world
      link
      fedilink
      English
      arrow-up
      16
      ·
      2 months ago

      The ones I put up in my house have a high tension spring inside the top. When you want to raise the blinds you lift them up when you want to lower the blinds you pull them down. They’re not fantastic but they work well enough. You have to kind of coax them to go up lift them up a few times but then again mine were the cheapest Walmart had available

      • Broken_Monitor@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        2 months ago

        I’ve got the Ikea version of these and they work great, no coaxing at all. Way easier than that stupid pull cord, I would never go back. Put them up all over the house. One of them went slightly crooked and I never did figure out why or how to fix it though. I think I will eventually get some higher quality replacements anyway.

      • JusticeForPorygon@lemmy.world
        link
        fedilink
        English
        arrow-up
        6
        ·
        2 months ago

        I think those are the ones being referred to. Nowadays they makes ones that look almost identical but don’t have the pullstrings. You can just raise and lower them from the bar on the bottom.

        • Soggy@lemmy.world
          link
          fedilink
          English
          arrow-up
          2
          ·
          2 months ago

          Which suck if you have windows higher than your head. Pullstring can be ten feet long and work just fine.

    • Ogmios@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      3
      ·
      2 months ago

      Mine have a hard “handle” with a string attached to it on a pulley. Twist the handle to adjust the angle, pull the string down on one side to open them, pull the string down on the other side to close.

    • Tarquinn2049@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      2 months ago

      We use honeycomb blinds here. You can get them in partially transparent or blackout. They are spring-loaded, and you really can’t use them wrong, pull them up or down as fast or as crooked as you want.

    • OZFive@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      2 months ago

      You lift them from the bottom and there is a system of gears and springs (citation needed) that assist with them being raised and hold them in place.

      Pull them down from the bottom and they come down (with some resistance).