Up or down? I’m still learning and trying to figure out the feed.

Also, how did you know it’s the feed? What should I be looking for?

Well the cylinder has a stroke length of ~8 inches (it’s a little less) it is 17 inches from the pivot point, the other arm is 6 inches from the pivot.

When the cylinder is fully extended, the crushing plate will move down about 3 inches which is greater than the width of most cans. (At least greater than all of the cans I have.)

It flattened cans sideways because I wanted to be able to put them through a shredder. It was very close to accomplishing that, if the base plate didn’t bend to shit, I’m sure it would have worked.

Yes! But the crushinator is a big girl, mine couldn’t hold a candle to that, so she squishes instead of crushes!

And those employees are sometimes literally fighting for their lives.

I absolutely support this, but why cant we as a society end subminimum wages period?

Fuck him up

Subtly?

I’m a freight conductor and yard shifts have similar times. For example, tomorrow my shift is 06:32-14:32. They never explain why, you just show up when you’re told.

The annoying one starts at 23:57.