Bambu X1C

Hatchbox ABS black and clear black

Been having a lot of failures lately with printing. Anyone else using hatchbox and having issues? Filament quality gone downhill?

Just got a kilo of black and it’s jammed up my print head four times. Switched from that to some clear black and I got some massive warping, 1/4” lift that popped my print (about 6”x3.5”) off with a spaghetti failure about halfway through. I’ve never had warping this bad.

  • d_ohlin@lemmy.worldEnglish
    4·
    15 days ago

    Personally, Hatchbox ABS has been one of my least favorite (read: pickiest) filaments. To each their own, but my luck with it has been less than stellar.

    I’ve switched to consistently using a glue stick and warping has largely ceased but had I not used it for my RatRig VCore3’s parts I would no longer be buying it lol. Definitely had more than my fair share of failures with it if all conditions aren’t ideal.

    • RememberTheApollo_@lemmy.worldOPEnglish
      1·
      14 days ago

      Well that’s too bad. I’ve been using them for years and they’ve been pretty consistent up until now. Might have to switch brands.

      • d_ohlin@lemmy.worldEnglish
        2·
        14 days ago

        Yeah I’m honestly not sure. I haven’t read that many similar reports to the issues I’ve had, which usually means it’s not a widespread issue…but all I can do is speak to my own experiences. Who knows lol ¯_(ツ)_/¯