This is the temp tower of my wood print experiment Cand even se much difference. It goes from 260 to 190. Below 225 gets really flimsy and above 240 melts. But even 230, the “best” one is really bad, and I’m not talking about retraction. Even the layers that melt are inconsistent.

Also it’s not humidity since the filament was in a filament dryer for.16hours.

edit: The nozzle is 0.8

can someone think of anything else?

  • FuglyDuck@lemmy.worldEnglish
    0·
    3 months ago

    Looks to me like the plastic isn’t getting hot enough fast enough.

    Is it just wood filament that isn’t printing right? Can you print pla or whatever on the .8mm?

    Does the filament brand suggest a range that’s higher than you normally print at?