I left the print over the weekend and I came back to spaghetti. It looks like something, caused the printer to push the print off its base like it was a poorly leveled bed?

I still have to watch the camera footage to see what failed, but I hope you guys get a chuckle out of the spaghetti monster like I did.

  • Koopa_Khan@lemmy.worldOPEnglish
    2·
    3 months ago

    I just picked up a pi4 b today and was tinkering with octoprint.

    So far it looks great, i just haven’t figured out how to get the pi camera module 3 working quite yet. The stream from octoprint just constantly tries to load.

    I’m excited to try some prints with it soon!

    • mvirts@lemmy.worldEnglish
      3·
      3 months ago

      Cool! The only advice I have for that is make sure it’s not plugged into the display connector 😹 I’ve wasted a good amount of time doing that myself.

      • Koopa_Khan@lemmy.worldOPEnglish
        2·
        3 months ago

        Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷

        I’ll have to give that camera connection a second look lol