cross-posted from: https://sh.itjust.works/post/63691946
Looking for advice on setting up a new whole home network and the direction to take of MoCA over existing cabling vs running new Ethernet Cat6A:
Recently in a new space that has an existing HomeConnect CSMAPDU9VPI with coax cables run throughout the home, which seems like a great candidate to just use MoCA and get up and running faster:
But I am also interested in “future proofing” the network setup and replacing the coax cables that are already run with Cat6A Ethernet, all connecting to a central 10G switch / homelab setup.
Is it worth the effort to re-run all of the cables and swap out the wall plates or just go with the simple thing an run with a MoCA setup? I’d really prefer to not spend on one setup with the plan to update in the future, but maybe that’s the compromise solution to get setup and running sooner.
The CSMAPDU9VPI is currently completely isolated from the cable line to the modem (picture above is old and shows a cable connected to the IN port, this cable is no longer connected) so I don’t think I have to worry about interference with my DOCSIS 3.1 service / modem.
Pros of MoCA:
-Easy to implement
-Don’t have to run new lines
-Reliable
-Up to 2.5gbps
Cons:
-Each run needs an moderately expensive adapter on either side, which also needs power
-Cable management at the endpoints can get messy
If you have one or two endpoints where you can tuck away some boxes, MoCA’s probably fine. If you want to wire up every room in your house, buy a roll of cat-6 and bite the bullet