I left the print over the weekend and I came back to spaghetti. It looks like something, caused the printer to push the print off its base like it was a poorly leveled bed?

I still have to watch the camera footage to see what failed, but I hope you guys get a chuckle out of the spaghetti monster like I did.

    • Koopa_Khan@lemmy.worldOPEnglish
      0·
      2 months ago

      I’ve been looking at this for a while. The camera I have on it is a security camera that i put on my desk while it prints if I’m gone.

      Do you think its worth pulling the trigger on a raspberry pie to get this set up?

      • mvirts@lemmy.worldEnglish
        3·
        2 months ago

        I’ve been using a pi3 b+ with octopi and so far it’s great even without obico, plus super easy to set up. I set up octopi to get my ender 3 away from high occupancy areas because the hot plastic VOCs were giving me paranoia :P I can recommend investing in a solid setup for any small computer used to drive 3d prints. My setup is a hack with no thermal management and a crap power supply and I’ve lost a couple of prints to unknown causes but I blame the raspberry pi (it’s almost always reporting under voltage events in the octoprint UI).

        Has anyone here run self-hosted obico? I’m not keen on the cloud version but if the failure detection works in self hosted mode I’m definitely going to give it a try.

        • Koopa_Khan@lemmy.worldOPEnglish
          2·
          2 months ago

          I just picked up a pi4 b today and was tinkering with octoprint.

          So far it looks great, i just haven’t figured out how to get the pi camera module 3 working quite yet. The stream from octoprint just constantly tries to load.

          I’m excited to try some prints with it soon!

          • mvirts@lemmy.worldEnglish
            3·
            2 months ago

            Cool! The only advice I have for that is make sure it’s not plugged into the display connector 😹 I’ve wasted a good amount of time doing that myself.

            • Koopa_Khan@lemmy.worldOPEnglish
              2·
              2 months ago

              Oh man, you should have seen me looking for the HDMI ports. I was very confused until I realized my mistake. Turns out that there’s more than one kind, who knew🤷

              I’ll have to give that camera connection a second look lol

      • ikidd@lemmy.worldEnglish
        0·
        2 months ago

        If you do long prints, yes. You can set it to stop the print automatically, or alert you to take a look.